← All stories
● Covered by 8 sources · 19 reportsHigh impact3 negative16 neutral

FAA Issues Nationwide Ground Stop Due to Communication and Equipment Issues

🔄 Updated 1d ago — new reporting from Ars Technica
New to BrevFeed? We gather this story from every outlet covering it into one summary — ranked by real-world impact, not just the latest headline — so you never miss what matters. What is BrevFeed? →

Key points

  • FAA issued a nationwide ground stop for all US flights.
  • The cause was communication issues affecting Air Route Traffic Control Centers.
  • An equipment outage was also cited as a contributing factor.
  • The ground stop resulted in 9,086 US flight delays.
  • Homeland Security stated no immediate suspicion of cyberattack.
  • The ground stop was lifted at 8:15 p.m. ET.
  • The ground stop was issued at 3:54 p.m. ET.
  • The ground stop was caused by overloaded routers in the air traffic control system.
  • The incident led to instability in radar and communication systems.
  • The ground stop resulted in more than 7,000 flight cancellations.
  • Transportation Secretary Sean Duffy blamed the outage on outdated air traffic control equipment.
  • The FAA lifted its third-ever nationwide ground stop.
  • The ground stop began at 3:36 p.m. EST.
  • The incident occurred on November 13.
  • The system uses legacy TDM telecom technology.
  • The FBI is reportedly investigating a software update as a potential cause.
  • The ground stop was caused by a new router installed during a copper-to-fiber optic line replacement.
  • The router flooded the Air Traffic Control system with over 1,000 connection attempts every 4 to 5 seconds.
  • The upgrade was performed by contractor L3Harris.
  • The incident occurred during routine maintenance at a remote FAA facility.
  • The ground stop resulted in over 11,000 flight cancellations across Friday and Saturday.
  • The ground stop was the longest halt in flight departures since 9/11.
  • Cisco products were involved in the technological disruption.
  • Bryan Bedford is the administrator of the Federal Aviation Administration.
  • Two HPE Juniper network routers grounded all US flights.
  • The routers were installed at FAA facilities in Arkansas and Texas.
  • The routers broadcast excessive data across the network.
  • The ground stop occurred last Friday night.
  • The issue started after a newly installed Juniper router, built by HP Enterprise, started broadcasting to a wide part of the network.
  • The incident did not affect Traffic Collision Avoidance System (TCAS).
  • United Airlines experienced a widespread system outage.
  • The United Airlines outage affected departing flights.
  • The United Airlines outage did not affect flights already in progress or United Express flights.
  • The United Airlines outage was not cybersecurity-related.
  • The United Airlines outage was reportedly due to a problem with a weight and balance calculator.
  • United Airlines resolved its technology issue by 6:13 PM ET.
  • The FAA paused new router installations on Tuesday.
  • The ground stop halted departing flights for over four hours.
  • The Wall Street Journal first reported the pause in router installations.
  • The FAA disabled over 60 already installed Juniper Networks routers.
  • The router was installed at an FAA site in El Dorado, Arkansas.
  • The ground stop impacted more than 1 million passengers.
  • More than 12,000 flights were canceled on November 13.
  • The number of canceled flights rose to more than 20,000 over the weekend.
  • Some international flights were allowed to depart prior to broader resumption of air traffic.
  • Transportation Secretary Sean Duffy plans to announce findings at a news conference as soon as Friday, November 2.

National Flight Disruption

On Friday afternoon, the Federal Aviation Administration (FAA) implemented a nationwide ground stop, halting all departing flights across the United States. This measure was enacted due to "extraordinary circumstances" and for safety reasons, preventing aircraft from taking off from departure gates.

The disruption led to significant travel delays, with FlightAware reporting 9,086 US flights delayed as of 5:19 PM ET.

Technical Issues Identified

The FAA cited communication issues impacting all Air Route Traffic Control Centers nationwide as a primary cause for the ground stop. U.S. Secretary of Transportation Sean Duffy confirmed these communication problems.

Additionally, the FAA's website indicated an "equipment outage" contributed to the incident. The agency's website itself experienced brief technical difficulties during this period.

Investigation Underway

FAA technicians are investigating the root cause of the disruption. While the exact nature of the problem remains unclear, federal officials have not publicly identified what triggered it.

Homeland Security Secretary Markwayne Mullin stated that there was no immediate reason to suspect a cyberattack or other national security threat, though no cause has been definitively ruled out.

Operational Impact

The ground stop directed all departing flights to remain on the ground until further notice. Inbound international flights were managed on a case-by-case basis, and planes already in the air were permitted to land.

Prior to the nationwide order, the FAA had already halted air traffic in Chicago due to air traffic control communications problems.

Updates

🕒 2026-11-20 · new reporting from Ars Technica
  • The ground stop impacted more than 1 million passengers.
  • More than 12,000 flights were canceled on November 13.
  • The number of canceled flights rose to more than 20,000 over the weekend.
  • Some international flights were allowed to depart prior to broader resumption of air traffic.
  • Transportation Secretary Sean Duffy plans to announce findings at a news conference as soon as Friday, November 2.
🕒 2026-11-18 · new reporting from Engadget
  • The FAA disabled over 60 already installed Juniper Networks routers.
  • The router was installed at an FAA site in El Dorado, Arkansas.
🕒 2026-11-17 · new reporting from CNBC Technology
  • The FAA paused new router installations on Tuesday.
  • The ground stop halted departing flights for over four hours.
  • The Wall Street Journal first reported the pause in router installations.
🕒 2026-11-17 · new reporting from Engadget, The Verge
  • United Airlines experienced a widespread system outage.
  • The United Airlines outage affected departing flights.
  • The United Airlines outage did not affect flights already in progress or United Express flights.
  • The United Airlines outage was not cybersecurity-related.
  • The United Airlines outage was reportedly due to a problem with a weight and balance calculator.
  • United Airlines resolved its technology issue by 6:13 PM ET.
🕒 2026-11-15 · new reporting from Tom's Hardware
  • Two HPE Juniper network routers grounded all US flights.
  • The routers were installed at FAA facilities in Arkansas and Texas.
  • The routers broadcast excessive data across the network.
  • The ground stop occurred last Friday night.
  • The issue started after a newly installed Juniper router, built by HP Enterprise, started broadcasting to a wide part of the network.
  • The incident did not affect Traffic Collision Avoidance System (TCAS).
🕒 2026-11-15 · new reporting from CNBC Technology
  • The ground stop was the longest halt in flight departures since 9/11.
  • Cisco products were involved in the technological disruption.
  • Bryan Bedford is the administrator of the Federal Aviation Administration.
🕒 2026-11-14 · new reporting from The Verge, TechCrunch
  • The ground stop was caused by a new router installed during a copper-to-fiber optic line replacement.
  • The router flooded the Air Traffic Control system with over 1,000 connection attempts every 4 to 5 seconds.
  • The upgrade was performed by contractor L3Harris.
  • The incident occurred during routine maintenance at a remote FAA facility.
  • The ground stop resulted in over 11,000 flight cancellations across Friday and Saturday.
🕒 2026-11-14 · new reporting from Hacker News Front Page, Ars Technica, Engadget, SecurityWeek
  • The ground stop was lifted at 8:15 p.m. ET.
  • The ground stop was issued at 3:54 p.m. ET.
  • The ground stop was caused by overloaded routers in the air traffic control system.
  • The incident led to instability in radar and communication systems.
  • The ground stop resulted in more than 7,000 flight cancellations.
  • Transportation Secretary Sean Duffy blamed the outage on outdated air traffic control equipment.
  • The FAA lifted its third-ever nationwide ground stop.
  • The ground stop began at 3:36 p.m. EST.
  • The incident occurred on November 13.
  • The system uses legacy TDM telecom technology.
  • The FBI is reportedly investigating a software update as a potential cause.

✨ This summary was generated by AI from the outlets' reporting listed below. It is not independently verified and may contain errors — check the original sources. How BrevFeed works →

The daily brief

One email each morning: the day's tech stories, clustered across outlets and summarized. No account needed.

One email a day. Unsubscribe in one click, any time.

Today's brief

Spend a few minutes, get the whole day. Every topic's top stories in one hands-free rundown — listen, watch, or read the transcript.

~4 min · 3 stories · Nov 21

▶ Play today's brief Listen on Spotify

New every morning, and the back catalogue is archived by date.

How outlets covered it

The US government will soon announce the root cause of a router outage that led to a nationwide ground stop by the FAA, impacting over a million passengers and thousands of flights. The incident stemmed from excessive data flooding the FAA Telecommunications Infrastructure network, causing instability in air traffic control communications and radar feeds.

The FAA has suspended installations of a Juniper Networks router model and disabled over 60 already installed units, believing it caused the November 13 US flight ground stop. A router at an Arkansas site malfunctioned during a modernization effort, flooding the air traffic control system with data. The agency is investigating the cause of the malfunction and has requested additional funding for system modernization.

The Federal Aviation Administration (FAA) has paused the installation of new routers following a nationwide ground stop that affected tens of thousands of flights. An overloaded router, part of an upgrade to convert the communications network from copper to fiber optic, caused the disruption by overwhelming systems feeding radar data to air traffic control.

United Airlines experienced a technology issue that disrupted some departing flights, reportedly due to a problem with a weight and balance calculator. The airline announced the issue was resolved by 6:13 PM ET, following a series of other recent tech outages across different sectors.

United Airlines experienced a widespread system outage that delayed departing flights but did not affect flights already in progress or United Express flights. The airline confirmed it resolved the unspecified technology issue, which was not cybersecurity-related and appeared unrelated to a recent FAA ground stop.

Two newly installed HPE Juniper routers at FAA facilities in Arkansas and Texas broadcast excessive data across the network, causing communication failures between air traffic control and pilots. This led to a nationwide ground stop for all US flights, marking only the third such event in US history.

The Federal Aviation Administration (FAA) has not identified the root cause of a nationwide flight departure halt, the longest since 9/11. Officials reported instability involving routers and networking equipment, including products from Cisco and L3Harris Technologies, leading to the grounding order to prevent further propagation of issues.

A nationwide ground stop for flights in the United States occurred due to a router overloading a critical communication system during a routine copper-to-fiber optic cable upgrade by contractor L3Harris. The upgrade, performed at a remote location, led to network instability and the cancellation of over 11,000 flights across Friday and Saturday.

A nationwide ground stop by the FAA was caused by issues with a new router installed during a routine copper-to-fiber optic line replacement at a remote FAA facility. The router flooded the Air Traffic Control system with connection attempts, disrupting radar and communications. The root cause, whether faulty hardware, misconfiguration, or contractor error, is under investigation.

The Federal Aviation Administration (FAA) experienced a nationwide ground stop due to a communications problem, disrupting thousands of flights. Officials found no evidence of a cyberattack, and the FBI is reportedly investigating a software update as a potential cause. The incident appears to stem from legacy equipment being overwhelmed by new patches and technology.

The Federal Aviation Administration lifted a nationwide ground stop that halted all US flights for hours on November 13, leading to hundreds of cancellations and diversions. Transportation Secretary Sean Duffy attributed the malfunction to the USA's "incredibly old air traffic control system" and its reliance on legacy TDM telecom technology, which overloaded with data.

grounds.top launched a live map displaying US flight data during a nationwide FAA ground stop on November 13, 2026. The tool visualizes airborne flights, missed departures, and airport recovery rates by comparing current data to the previous week's activity.

The Federal Aviation Administration (FAA) lifted its third-ever nationwide ground stop, which halted all domestic departures for several hours. The FAA Secretary Sean Duffy attributed the incident to decades-old analog air traffic control equipment that cannot meet current demands, warning of future occurrences without system updates.

The Federal Aviation Administration (FAA) grounded all flights across the United States due to an equipment outage and communication issues affecting multiple Air Route Traffic Control Centers. This national ground stop prevented aircraft from taking off, causing widespread disruption to air travel.

The FAA issued a nationwide ground stop for all US airport takeoffs due to communication problems affecting Air Route Traffic Control Centers. This action was taken for safety reasons, with planes already in the air permitted to land, causing 9,086 US flights to be delayed.

The Federal Aviation Administration (FAA) issued a nationwide ground stop for all U.S. airports due to a communication issue affecting all Air Route Traffic Control Centers. The cause of the disruption is under investigation, with officials not yet confirming if it is related to a cyberattack.

The Federal Aviation Administration (FAA) issued a nationwide ground stop for all flights in the United States due to unspecified "extraordinary circumstances." This action halted air traffic across the country, causing widespread disruptions to travel.

The Federal Aviation Administration (FAA) issued a national ground stop for all flights in the United States due to a system outage affecting its Notice to Air Missions (NOTAM) system. This action halted all domestic departures and arrivals, causing widespread disruptions to air travel.

The Federal Aviation Administration (FAA) issued a nationwide ground stop for departing flights, lasting over four hours, due to overloaded routers in the air traffic control system. This incident led to the cancellation of more than 7,000 flights and caused instability in radar and communication systems across the country.