← All stories
● Covered by 1 source · 1 reportLow impact1 neutral

Student Builds 92% LEGO 3D Printer for Under $180, Presented at RepRap Festival

🔄 Updated 7d ago
New to BrevFeed? We gather this story from every outlet covering it into one summary — ranked by real-world impact, not just the latest headline — so you never miss what matters. What is BrevFeed? →

Key points

  • Student Adam Turaj built "Studprint," a 3D printer from 92% LEGO.
  • Total cost was $173.35, with $30 for LEGO parts.
  • Uses BTT SKR Pico, Raspberry Pi Zero 2 W, NEMA 17 motors.
  • Presented at Rocky Mountain RepRap Festival 2026.

Project Overview: Studprint

Adam Turaj, a Mechatronics Engineering student, developed an open-source 3D printer named "Studprint." This printer is notable for being constructed almost entirely from LEGO bricks, with only 13 non-LEGO components. The project was initiated as part of Hack Club's Infill challenge, which provided a $350 grant for participants to design and build 3D printers from scratch.

Cost and Components

The total bill of materials for Studprint amounted to $173.35. Of this, $30 was spent on LEGO pieces, which constitute 92% of the printer's physical structure. Key electronic components, each priced around $25, include a BTT SKR Pico V1.0 control board, a Raspberry Pi Zero 2 W for wireless connectivity, and a Mean Well LRS-150-24 power supply. The printer also incorporates five NEMA 17 stepper motors and a Trianglelab V6 Extruder.

Design and Construction

Turaj designed Studprint using SOLIDWORKS, focusing on using "classical LEGO" bricks and avoiding LEGO Technic pieces where possible. Even the build plate is a LEGO block, and the leadscrews are made from LEGO. The printer successfully produced a Benchy print in 1.25 hours, sliced in Klipper.

Recognition and Presentation

Turaj's project earned him an invitation to the Rocky Mountain RepRap Festival 2026. There, he presented Studprint to an audience of over 4,000 attendees and met industry figures such as Prusa CMO Zack Freedman.

✨ This summary was generated by AI from the outlets' reporting listed below. It is not independently verified and may contain errors — check the original sources. How BrevFeed works →

The daily brief

One email each morning: the day's tech stories, clustered across outlets and summarized. No account needed.

One email a day. Unsubscribe in one click, any time.

Today's brief

Spend a few minutes, get the whole day. Every topic's top stories in one hands-free rundown — listen, watch, or read the transcript.

~4 min · 3 stories · Nov 21

▶ Play today's brief Listen on Spotify

New every morning, and the back catalogue is archived by date.

Reporting from

A Mechatronics Engineering student created "Studprint," an open-source 3D printer constructed with 92% LEGO parts, costing $173.35 in total. The project, which used classic LEGO bricks and common 3D printer electronics, was presented at the Rocky Mountain RepRap Festival 2026.